Mercedes-Benz GLB 2021 Series, Operator'S Manual

Page: 169 / 446

#
Check if the transmitter frequency of the
remote control has the frequency range of
280 to 868 MHz.
Radio equipment approval number:
R
NZLMUAHL5 (USA)
R
4112A-MUAHL5 (Canada)
#
Press and hold button 1 , 2 or 3 that you
wish to program.
Indicator lamp 4 flashes yellow.
% It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
#
Release the previously pressed button.
Indicator lamp 4 continues to flash yellow.
#
Point remote control 5 from a distance of
0.4 in (1 cm) to 3 in (8 cm) towards button
1 , 2 or 3 .
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green contin‐
uously. Programming is complete.
R
Indicator lamp 4 flashes green. Pro‐
gramming was successful. Additionally,
synchronization of the rolling code with
the door system must also be carried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
% The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronizing the rolling code
Requirements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the
garage door or door drive.
R
The vehicle as well as persons and objects
are located outside the range of movement
of the door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1 , 2
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles
from a distance of 0.4 in (1 cm) to 3 in
(8 cm) front of the inside rearview mirror.
You should test every position for at least
25 seconds before trying another position.
#
Hold remote control 5 at the same angles
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
#
Note that some remote controls transmit
only for a limited period, press button 6 on
Driving and parking 167