Mercedes-Benz 190 E 2.6 1989, Owner'S Manual

Page: 36 / 117

Caution!
Do not remove head restraints except
when mounting seat covers. For re­
moval refer to “ Practical Hints” ,
page 92. Whenever restraints have
been removed be sure to reinstall
them before driving.
Important!
Prior to operating the vehicle, the
driver should adjust the seat height for
proper vision as well as fore/aft place­
ment and seat back angle to insure
adequate control, reach, operation,
and comfort. The head restraint
should also be adjusted for proper
height.
Both the inside and outside rear view
mirrors should be adjusted for ad­
equate rearward vision. Fasten seat
belts. Infants and small children
should be seated in a properly se­
cured restraint system that complies
with U.S. Federal Motor Vehicle
Safety Standard 213 and Canadian
Motor Vehicle Safety Standard 213.1.
All seat, head restraint, and rear view
mirror adjustments as well as fast­
ening of seat belts should be done be­
fore the vehicle is put into motion.
The inflation pressure of the air cush­
ion can be varied between position “0”
= without pressure, and position “4”
= maximum pressure, by changing
the pressure regulator (1) setting.
in addition, the cushion height may be
changed to five different settings be­
tween position “A ” = lowest setting,
and “ E” = highest setting, by varying
the height regulator (2) adjustment.
If the engine is turned off, the last
cushion setting is retained in memory,
and automatically adjusts the cushion
to this setting when the engine is
restarted.
O rthopedic Seat Backrest
Some models may be equipped with
orthopedic seats. These seats have
inflatable air cushions built into the
backrest to provide additional lumbar
support. The amount of cushion height
and curvature may be adjusted after
turning the key to steering lock
position 2.
34