MERAWEX ZUP-230V, User Manual, Page: 10 / 24

User manual ZUP-230V Nr dok. 0697.00.95-02.3
9/15
Description of 230Vac distribution packet of ZUP power supply.
L
H
A
L
CS
P
P541.2
AC-1
AC
-3
AC
-2
AC
-4
L N PE
L N
4A AC-4B N
2 3 0 V
T2 + T3
IN W
AL P
+ - + - + -
T2 : m in
1 2 3 h 5 3 0 2 0 1 0
T3 : s
T1 : h
1
2 5 3 0 1 0 5 2 1
T1 : m in
CSP PARA M
ON OFF
2A AC-2B N AC-3 N AC-1 N
G
2
0
1
ZAS ZSP
CSP WYUSZ
PE
ZST TEST
P
R
O
G
ZAS
W Y IN W ZAS 2 3 0 V
PR AC A
ZIN W - 2
ZIN W - 1
1 2 5 6
O N
3 4 7 8
1 2 5 6
O N
3 4 7 8
+INW +AKU
Fig.7. View of 230Vac distribution packet of ZUP-230V power supplies.
Description of 230Vac distribution packet components.
Designation Description
Connectors
ZAS 230V 230Vac mains power input (*)
WY INW 230Vac inverter output (*)
AC-1, AC-2
AC-3 AC-4 Outputs for powering external devices and their corresponding fuses.
PE Additional contact (connector) of the PE mains (unused).
ZAS ZSP 230V Additional 230Vac mains output (unused).
PROG UP programming connector (do not connect!)
G201 Digital communication connector (do not connect!).
WYUSZ
Fault output signal - isolated OC output (connection with ZSP121N-DR power
supply) (*)
- CSP line fault after 90s;
- battery voltage below 24V;
- no voltage at the inverter output after 8s.
CSP
Fire alarm signal input from the Fire Alarm Control Panel:
- alarm state must last longer than 2s;
- see CSP PARAM and AL CSP.
ZAS External 24Vdc power (*)
+INW Positive power bus of inverter. (*)
+AKU Positive pole of battery bank. (*)
Buttons
TEST
Button for testing power supply (simulating a fire alarm):
- power supply reacts when button is pressed for longer than 2s;
- the button allows to shorten T2+T3 (see LED T2+T3), but only after fire alarm.
ZST
The button allows you to start power supply from battery ("cold start"):
- see point 5.7.1
Switches
CSP PARAM Switch enabling parameterization of CSP input: