85-03-00955
P a g e
|
42
2.) PULL
3.) ROTATE
4.) RELEASE
1.) INSERT
ML39 DOOR OPERATION
To Remove Door
Use the glass latch tool to disconnect the spring latches from the glass frame. Insert tool into hole in latch, pull towards
you and Rotate 90 degrees to disengage top latches. Remove tool. There are two spring latches on top of this gas fire-
place.
With both hands, rotate top edge of glass frame away from unit 8 inches.
Lift glass frame up 1 inch, at an angle, and
move away from unit. Door is now free from unit.
To Replace Door
Identify small tabs that protrude downward on the bottom
left and right corners of glass frame. Identify a rectangle
slot on the bottom right and left corners of firebox opening
sides.
Carefully line up the bottom corner tabs in glass frame
bottom corners with slots in firebox bottom left and right
corners. Insert tabs into slots and center glass frame over
firebox, left to right.
After door has been placed into slots, rotate door towards
firebox until gasket seal is touching the firebox frame.
Use the tool provided to connect the spring latches to the
glass frame. Insert tool into hole in spring latch, pull latch
towards you, rotate latch so the hook is facing downward
then release latch to hook to door frame.
Door is now connected and sealed to unit.
