Getting Started
Page 33
2.4.4
Connecting the Power Supply
Connect an external power supply:
»
Check the power configuration and coding labeling on the system for the exact config-
uration and pin assignment.
Figure 6.
Power configuration and coding labeling
»
Plug an external power supply to the power inlet connector.
2.4.5
Starting Up the System
Carry out the following steps to start up the system:
»
Power up the system.
»
You can start up the UEFI firmware setup menu by hitting the <Esc> or <DEL> key.
»
Now you can make configurations in the UEFI firmware.
2.4.6
Configuring the UEFI Firmware for PXE Boot
To enable PXE booting of the BL51E, configure the UEFI firmware as follows:
For UEFI mode:
-
Menu
MEN
:
Setup Mode [
Extended
]
-
Menu
Advanced
:
Network Stack Configuration > Network Stack [
Enabled
] > IPV4
PXE Support [
Enabled
]
For Legacy BIOS mode:
-
Menu
Advanced
:
CSM Configuration > CSM Support [
Enabled
]
-
Menu
Advanced
:
CSM Configuration > Option ROM Execution > Network [
Legacy
]
-
Menu
Advanced
:
CSM Configuration > Option ROM Execution > Video [
Legacy
]
Make sure that an earthing cable has been connected to the system
before connecting an external power supply and switching on the system.
