Memotec NetPerformer SDM-9120 Series, Hardware Installation Manual

Page: 81 / 161

Product Description
Memotec Inc. 4-13
4.7 Ethernet Ports
4.7.1 Ports
•
2 fully routed Ethernet IEEE 802.3 LAN interfaces with two optional SFP slots for
the SDM-9140e, each of which can accept a 1000Base-LX Ethernet optical SFP
or a 1000Base-T RJ-45 electrical SFP.
•
6 additional Ethernet ports for the SDM-9140e connected through an integrated
LAN switch.
•
RJ-45 10/100 Base-T connectors and 1000 Base-T (for the SDM-9140).
•
Each port can be configured with 6 IP addresses, providing a maximum of 12 IP
addresses per unit.
•
Auto-detect speed, 10 or 100 Mbps or 1000 Mbps (for the SDM-9140).
•
Frame types: Ethernet II, IEEE 802.2, 802.3, SNAP.
•
Ethernet interface: Ethernet II and IEEE 802.2, 802.3.
•
Standards: IP RIP V1/V2 or Static, OSPF, NAT, IP Multicast IGMP V1/V2 PIM-
DM, BOOTP/DHCP Relay, DHCP client, IPX RIP and SAP, LLC2, 802.1p/q
prioritization and VLAN, 802.1D Spanning Tree Protocol (STP), MAC Layer.
•
Filter Criteria: Based on protocol, address (source, destination or SAP) or custom
filtering.
For information on connecting to the LAN hub, refer to “Connecting the LAN Hub” on
page 3-39 .
4.7.2 LAN Status LEDs
For the SDM-9120/9220/9230 units,
two pairs of LAN status indicators are located below
the Ethernet ports on the rear panel of the chassis (refer to “Rear View of the SDM-9220/
9230 UAC” on page 4-5 ). The LEDs for Ethernet port 1 are located on the left, and the
LEDS for Ethernet port 2 are located on the right.
These LEDs indicate the following:
• LINK:
Goes on when the corresponding LAN connection passes the Link
Integrity test. In addition, the LED color indicates the LAN speed:
-
Amber:
Link integrity at 100 Mbps
-
Green:
Link integrity at 10 Mbps
-
Off:
No link integrity signal detected
• ACT:
Goes on (green) when there is activity on the corresponding LAN port (LAN
traffic transmitted or received).
For the SDM-9140
, two LEDS are embedded in each RJ-45 Ethernet connector (refer to
“Front View of the SDM-9140e” on page 4-7 ).
The Ethernet Port link is up when the
Left
LED is on. The LEDs indicate the following: