15
Operation
Product-specific default control parameter settings for
service personnel.
Setting the hollow shaft encoder for
the set yarn feed rate
Enter the yarn feed rate per machine revolution set
before assembly (see the section Setting the hollow
shaft encoder ratio).
Start the knitting machine.
Measure the actual yarn feed rate per machine
revolution.
If the actual yarn feed rate does not match the origi-
nal yarn feed rate, you must adjust the hollow shaft
encoder ratio.
Start the knitting machine and measure the actual
yarn feed rate per machine revolution again.
Repeat this procedure until the actual yarn feed
rate per machine revolution matches the yarn feed
rate measured before installation on the knitting
machine.
