15
TRANSPORTATION AND STORAGE
1.
Place a dust cap on the cylinder valve outlet whenever the cylinder is not in
use. Only install the type of dust cap on the cylinder valve outlet that
is provided with the cylinder valve. Other types of caps or plugs
may result in leakage.
2.
Always transport in an upright position.
3.
Do not smoke when transporting your cylinder.
4.
Keep cylinders out of direct sunlight and away from sources of heat.
Your regulator is equipped with a Q.C.C. Type 1 quick connect system. It will not allow gas to flow until a
positive seal has been made. It has a flow-limiting device that will restrict the flow of gas to 10 cubic feet per
hour (0.28 cubic meters per hour).
TO PLACE THE CYLINDER INTO THE GRILL CABINET
1.
Unscrew the screw on the back of the cylinder tray.
2.
Place the tank onto the sliding LP cylinder tray.
3.
The front of the tank valve should face to the front of the cabinet.
4.
Tighten the screw of the back of the cylinder tray to secure the LP cylinder.
5.
Lock the LP cylinder tray in place by turning the LP cylinder tray stopper
to the right.
TO CONNECT THE CYLINDER TO THE REGULATOR AND HOSE
1.
Be sure the LP cylinder is “OFF” by turning the hand wheel clockwise
until it stops.
2.
Place the cylinder into the base cabinet shelf of the grill with the valve
facing outward and secure with the cylinder retaining bolt.
3.
Be sure all burner controls are turned to the “Off” position.
4.
Remove the safety cap from the cylinder valve.
5.
Center the nipple of the regulator into the cylinder
6.
Turn the black nut clockwise until it stops.
Hand Tighten Only.
Do Not Use A Wrench.
Dust Cap
CAUTION
The pressure regulator and hose assembly provided with this gas grill must be used. This regulator is set
for an outlet pressure of 11 inches water column. Replacement pressure regulators and hose assemblies
must be those specified in the parts list.
!
Regulator and LP Cylinder Connections
