Installation
Rev 1.0
Mellanox Technologies
38
Figure 25: Inserting the Caged Nuts
3. Clip 6 caged nuts into the holes in the rack on the side of the rack you will be sliding the gate-
way into. Check that both sides of the gateway, power side and connector side, are at the same
level in the rack.
4. Clip 4 more caged nuts into the holes on the opposite side of the rack. Check that both sides of
the gateway, left and right, are the same level in the rack.
5. Slide the rail into the rail slide.
6. Using two of the bolts for each corner install the rails and rail slides in the rack. Do not
tighten the bolts yet.
Figure 26: Slide the Rail into the Rail Slide
Side you will slide
the gateway into
Second side
This side of the rail kit goes on the side of the rack you will
slide the gateway into. This is the same side of the gateway
that will be next to the vertical support.
