MELAG Careclave 618, Technical Manual

Page: 15 / 34

3 Setup and installation
15
6. Close the door.
7. Press the power switch to shut down the device.
8. Remove the power plug to disconnect the device from the power
supply.
Connecting the feed water supply (installation examples)
The following pages provide examples for the recommended installation types for the feed water supply. The connection
of a different water treatment unit with the same water quality is possible after consultation with MELAG.
PLEASE NOTE
For detailed information on the cold water connection of the water treatment unit, see the user manual
of the unit.
Installation material
The following additional material can be ordered as required:
Qty. Article Art. no.
1 2-way compressed air distributor ME80220
1 Surface-mounted siphon ME37410
1 3/4” water inflow tap with safety combination ME37310
1 Additional water tap with unit combination (for connection
to a pre-existing angle valve) ME58130
1 Pressure increase pump for MELAdem 47 ME22500
1 Filling pump P10 ME65010
1 MELAjet spray pistol ME27300
Example 1: Use of the water treatment unit MELAdem 53/53 C (HD)
Cut the PUR 6/4 mm (5 m) hose for the compressed air supply (4) and the feed water connection (5) into two suitable
pieces.
Connect the water treatment unit MELAdem 53/53 C to the feed water connection (5) of the device either via a water
branch (17) or by means of a water distributor (19). Insert the filter for MELAdem (18) in between.
Fix the safety combination HD (16.3) to the house wall, observing the flow direction indicated on the safety combination.
Keep the minimum distance of the drop section under the safety combination.
Cut the PTFE 8/6 mm (5 m) hose for the overflow funnel (2) and the wastewater connection (3) into two suitable pieces.
The direct connection of the water treatment unit to the domestic water system requires the installation of the water stop
(1).