MEITRACK T366 User Guide
Copyright © 2018 Meitrack Group All rights reserved. - 5 -
1
Copyright and Disclaimer
Copyright © 2018 MEITRACK. All rights reserved.
and
are trademarks that belong to Meitrack Group.
The user manual may be changed without notice.
Without prior written consent of Meitrack Group, this user manual, or any part thereof, may not be reproduced for
any purpose whatsoever, or transmitted in any form, either electronically or mechanically, including photocopying
and recording.
Meitrack Group shall not be liable for direct, indirect, special, incidental, or consequential damages (including but
not limited to economic losses, personal injuries, and loss of assets and property) caused by the use, inability, or
illegality to use the product or documentation.
2
Product Introduction
The T366 is a vehicle GPS tracker with IP67 water-resistance rating and can be installed into cars, motorcycles,
yachts, and boats. This unit is equipped with a 1-Wire interface, which can be connected to the iButton reader,
temperature sensor, fuel level sensor, etc. In addition, you may choose the T366 standard version, T366 RS232
version or T366 two-way calling version depending on your preference for more peripheral expansion.
2.1
Product Features
2.1.1
Harsh Acceleration/Braking Alert
You can detect the harsh acceleration/braking alert by setting the limit value.
Cautions on device installation:
1.
The device should be installed into the vehicle according to the following direction.
2.
The device installation angle cannot exceed 15 degrees.
The default harsh acceleration and braking alert values are 230 mG and -300 mG respectively.