73
action). Always select the most appro-
priate torque for the job in hand.
Do not use the drill setting for
screwdriver work.
Tensioning a tool
Traditional screwdriver bits, bit
holder and drills up to a diameter of
13mm can be used in the chuck (1).
Only use a tool that can be clamped
securely in the chuck and which is
designed for use with this machine.
See „Technical data“.
The machine has a quick-action
chuck (1). This allows you to change
accessories by hand quickly and
without a chuck key.
• Open the claws of the quick-ac-
tion chuck. To do this, rotate the
quick-action chuck anti-clock-
wise. Open the quick-action
chuck far enough to be able to
insert the tool.
• Insert the tool in the quick-action
chuck.
• Rotate the quick-action chuck
clockwise and tighten securely.
CAUTION! Accidentally
switching the machine on is
an injury risk. Set the switch for
the rotation direction to the middle
setting when the machine is at a
standstill in order to activate the
lock for the On/Off switch.
CAUTION! Risk of cuts.
• Wear gloves to insert a drill into
the quickaction chuck.
• Tighten the quickaction chuck
to clamp the tool in place.
The chuck of right/left rotat
ing machines is always fixed
with a leftthreaded screw. This
must be loosened from the front
through the chuck (1) before
changing it. Leftthreaded screws
can only be loosened by turning
to the right.
Switching on and off (Figure 6)
•
Switching on:
Press the On/Off switch (10).
The screwing/drilling process
starts. During the screwing/ drill-
ing process, keep the switch
pressed. The LED working
light (11) will light up.
•
Switching off:
As soon as the screw or drill has
been screwed in or removed fully,
release the On/Off switch. The
screwing or drilling process is
completed, and the LED working
light will go out.
LED working light (Figure 7)
When the machine is switched on,
the LED working light (11) is lit to
provide better vision and to enable
safer work in darker areas. The LED
working light goes out when the On/
Off switch is released.
CAUTION! LED working light!
Do not look directly into the
MW-5451280-Bedien-2008.indd 73
MW-5451280-Bedien-2008.indd 73
26.08.20 09:07
26.08.20 09:07
