• Saw blades that do not correspond
to the characteristic data specified in
this operating manual may not be
used.
• Ensure that all of the moving parts of
the saw blade protector are able to
move without catching.
• The splitting wedge should always be
used and be set correctly, except
when carrying out insertion cuts.
• Only use sharp saw blades and
suitable accessories.
• Fix small wooden items in place firmly
before processing. Never hold them
by hand.
• Do not use flanges/flange nuts with
drilled holes that are larger or smaller
than those of the saw blade.
• Do not brake the saw blade by hand.
• The machine is not to be used for
stationary operation.
• If connection cables are damaged,
they must – in order to reduce the
risks – be replaced by the
manufacturer or by their customer
service representative.
Safety marking
The symbols on the housing mean the
following:
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety“ voluntary
quality mark
CE Mark (conformity to
European safety standards)
Housing is double insulated
Wear safety goggles!
Wear ear defenders!
7 – Installation and setting
Parallel cutting (Figure 2)
1. Undo the locking screw (4).
2. Adjust the parallel stopper (11)
according to the scale, pay attention
to the width of the saw blade
CAUTION! Produce a test cut
using a piece of waste wood.
Notch A – vertical cut 90°
Notch B – angled cut 45°
Cutting depth (Figure 3)
1. Undo the screws for the cutting
depth setting (9).
2. Swivel the saw bench (3) down.
3. Set the cutting depth using the
scale. Tooth tips must protrude
approximately 2 mm out of the wood.
4. Tighten the screws for the cutting
depth setting (9).
44
5403520-Handkreiss_man 06.02.15 13:34 Seite 44
