Meister 5404300, Translation Of The Original Instructions

Page: 87 / 160

GB
Operation
87
Inflating valves using the adapters
A 6-piece adapter set and 3 screw nozzles are included. You can inflate bicycle tyres, air
mattresses and other products using the adapters. The adapter set is located in a pull-out
compartment
20
under the handle.
The following overview shows you which adapters are suitable for which purpose:
Adapter/nozzle Use
Quick valve adapter
12
Bicycle valve (Presta valve, Dunlop valve)
Ball needle
14
Balls
Conical screw nozzle
8
Screw valves (paddling boats, kayaks, pool, etc)
Conical universal adapter
13
and
15
Airbeds, etc.
Stepped screw nozzle
9
Venting valves (e.g. as in an airbed)
8 mm screw nozzle
10
All valves with an inner diameter > 8 mm
(air mattresses, pools, etc.)
–
To open the valve, squeeze the valve cap
together slightly before inserting the nozzle.
If you want to pump up products using the screw nozzles, proceed as follows:
F
1. Make sure that the on/off switch
1
is in position “
0
”.
2. Press the lever on the quick-locking mechanism
19
down.
3. Insert the nozzle adapter
11
into the quick-locking
mechanism then release the lever again.
4. Screw the desired screw nozzle
8
,
9
or
10
on the nozzle adapter.
5. Make sure that all connections are secure.
6. Insert the screw nozzle into the valve.
7. To turn on the compressor, set the on/off switch to
the “ I ” position. You can read the working pressure
on the gauge
4
.
8. To fill with air, press the trigger
18
and check the pressure on the gauge.
9. To deflate, press the drain valve
5
and check the pressure on the gauge.
10. Once the desired or the maximum allowable working pressure is reached, set the on/off
switch to the “ 0 ” position.
11. If you have finished using the compressor, unplug the power plug from the power socket
and allow the compressor to cool.