Page 6
S
ECTION
3 - I
NSTALLATION
3.5
Priming the Detergent and Rinse Aid Lines
After the machine has been connected to appropriate
detergent and rinse aid containers, the supply lines
must be primed to remove air from the lines. To prime
the lines, use the following procedure.
3.6
Checking for Correct Chemical Concentration
The normal settings for chemical injection are:
•
Detergent - 0.192 oz. per gallon of wash water (1.5
ml per liter).
•
Rinse aid - 0.038 oz. per gallon of rinse water (0.3
ml per liter).
To check if the normal settings are correct for your
chemicals,
RUN THREE EMPTY LOADS
to completely
cycle the water supply and obtain accurate test results.
This will only take a few minutes. Then, run a sample
load with soiled ware and examine the results.
•
If the detergent setting is too low, the ware will not
be adequately cleaned. In some cases, this can
be corrected by simply selecting a longer cycle
time (using the Cycle Select II, Extended or Cycle
Select III, Heavy buttons), but the detergent
concentration may also need to be adjusted.
•
If the rinse aid setting is too low, spotting or
streaking may occur on the ware.
•
If too much of either chemical is added, the extra
chemicals will be wasted. This is often difficult to
detect except by determining how long your
chemical supplies last. If the chemicals are being
exhausted quickly, you may need to have the
chemical concentration adjusted.
IN ALL CASES, ANY ADJUSTMENTS OF THE
FACTORY CHEMICAL INJECTION SETTINGS ARE
TO BE PERFORMED ONLY BY A MEIKO AUTHORIZED
SERVICE AGENT. CHANGES BY UNAUTHORIZED
PERSONNEL WILL VOID YOUR WARRANTY.
If you need to contact your Authorized Service
Agency, please contact MEIKO Technical Support at
1-800-868-3840
.
To turn the machine on, press and hold
or
open the door. The display will turn on.
Press the
key next to the
action symbol on
the display.
The initial choice on the Action menu is
PRIME
DETERGENT SUPPLY
. Press the
key next to the
check mark to prime the detergent pump. A timer
will count down the remaining time for the procedure.
At the end of the procedure, the display will return to
the Action menu. Press
next to the
arrow to select
PRIME RINSE AID SUPPLY
.
Press the
key next to the
check mark to
prime the rinse aid pump. A timer will count down the
remaining time for the procedure.
At the end of the procedure, the display will return to
the Action menu. Press the (back) key to return to
the startup menu.
Press and hold
for 2 seconds, until the display
reads
SHUTDOWN MACHINE?
Then press the
next
to the
check mark to turn the machine off.
