Operating instructions GK 60
Datei:BA_GK60_9670999_EN_1997-08.doc
9670999
16/24
W e reserv e the right to change ex ecution and construction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Programme start
After having pressed the „programme start key“ on the sensor touch panel the green lamp
in the start panel is lit up and the wash cycle runs automatically.
If you state that the wrong programme was selected only after having pressed the
„programme-start-key“ the actual programme cycle can be interrupted by actuating the
key „programme-off“. After pressing the key „filling“ another programme can be
selected.
9.4.1 Remove the cleaned items
After finishing the wash programme the green lamp goes out.
Open the tank cover.
Remove the basket cover.
Remove the wash basket with items.
10
Separate spin programme
This programme allows that the items are spun without previous wash cycle. The
following operating cycles must be oberserved:
Press the key "fill".
After finish of the filling process press key „programme-off“.
Select the spin time.
Press the key "programme-start".
The items are spun for the pre-
selected time. By a repeated pressing of the „programme-
start-
key“ the spinning process can be repeated as often as required.
Should the spinning programme be followed by a wash programme, it can be newly
programmed after actuating the „programme-off“ key and the „filling“ key.
11
Shutting down the appliance
Close tank cover.
Press key "programme -off".
Press key "drainage".
The drainage is automatically effected and is finished as soon as the green ligh goes out.
Open the tank cover.
Remove basket carrier.
Remove dirt strainer for cleaning.
