MEIER-BRAKENBERG D-Line + MBWeich 4, Assembly Instructions And Operator'S Manual

Page: 12 / 59

Seite 12
2.6 Further hazards
WARNING
Injury hazard from hydraulics/pneumatics!
Work on hydraulic equipment may only be done by qualified personnel. All lines, hoses and fit-
tings must be properly installed and checked regularly for leaks and externally visible damage.
Damage must be repaired immediately. Splashing liquids can lead to injuries.
Before starting repair work depressurize system sections and pressure lines to be opened. Se-
cure the system against being switched on again.
CAUTION
Injury hazard from sharp edges!
Wear suitable protective clothing (incl. protective gloves).
WARNING
Injury hazard due to incorrect spare parts!
Incorrect or faulty spare parts may cause damage, malfunctioning or total failure, and may also
give rise to safety hazards.
Use original spare parts only.
Procure spare parts via MEIER-BRAKENBERG GmbH & Co. KG.
Special works within the scope of use
If the system is switched off for special work, such as maintenance and repair work, it must be
secured against unexpected restarting.
2.7 Safety devices and guards

Before switching on the system always make sure that all safety devices and guards
have been fitted properly and are functional.

When subcomponents are delivered the plant operator must ensure that the guards are
fitted according to the rules.

You must not bypass or remove safety devices and guards or defeat them in any other
way.

Check the functioning of all the system
‘s safety devices regularly.
2.8 Obligations of the plant operator
The system is used in industrial plants. The plant operator is therefore subject to the legal re-
quirements concerning health and safety at work.
In addition to the safety information in these manual it is necessary to comply with the safety,
accident prevention and environmental protection regulations valid for the area of application,
where the system is being used. The following applies in particular:

The plant operator must ensure that the system is used as intended (see chapter 2.4
“Intended use“)