MEIER-BRAKENBERG D-Line + MBWeich 4, Assembly Instructions And Operator'S Manual

Page: 18 / 59

Seite 18
3.3 Installation of additional modules
Important information!
The hoses must be installed in such a way that they cannot rub against other com-
ponents/sharp edges. The hoses must not be bent too much. Non-observance will
reduce the lifetime of the hose.
The pressure relief module for connection to the connection
pipe (Art. 7113 - STANDARD) is mounted between the hydrau-
lic hose of the pump unit and the connection pipe. For the con-
nections of the T-piece, the information in chapter 3.5.2
“Cutting
ring fittings
” must be observed. The mounting position of the
valve should be with the solenoid upwards. The hose at the
connector should be led into the drain. The cable of the valve
connector is connected to the Touch Controller according to the
specifications in the chapter 7
“Anschlusspläne/Wiring plans”.
The additional module 2-house without pressure relief
(Art. 7114) is mounted near the pump unit on a wall or alterna-
tively in the pump unit on the rear wall of the angle plate. The
mounting position of the valves should be with the solenoids
pointing upwards. The connector between the valves is con-
nected to the hydraulic hose of the pump unit. The two hydraulic
hoses behind the valves are connected to the connecting pipes
to the two compartments. The cable of the double valve con-
nector is connected to the Touch Controller according to the
specifications in the chapter 7
“Anschlusspläne/Wiring plans”
(version LC-2 or LCS-2 required!).
The additional module 2-house with pressure relief (Art. 7115)
is mounted near the pump unit on a wall or alternatively in the
pump unit on the rear wall of the angle plate. The mounting po-
sition of the valve block should be with the solenoids pointing
upwards. The right connection (P) is connected to the hydraulic
hose of the pump unit. The hose at the nozzle (R) is led into the
drain. The two hydraulic hoses behind the valve block (A1 and
A2) are connected to the connecting pipes to the two compart-
ments. The cables of the double valve connectors are connect-
ed to the Touch Controller according to the specifications in the
chapter 7
“Anschlusspläne/Wiring plans” (version
LC-2 or
LCS-2 required!). The two valves at the inlet of the valve block
control the two outputs. The two valves at the block outlet each
serve as pressure relief.
NOTE
All protective conductors of the modules must be connected to the protective conductor ter-
minal in the touch controller. The multicore cables must be connected according to the wire
colors in the chapter 7
“Anschlusspläne/Wiring plans”. For the double valve connectors of the
2-house modules, the position of the respective connectors must be taken into account
(compare the function of the valves in the wiring plans).