Megger TM1700 Series, User Manual

Page: 53 / 92

BL1448GE ZP-BL16E TM1700-sEriEs 53
4 CABA LOCAL
4]
Connect the transducer to the specified chan-
nel. Confirm by pressing “OK”.
5]
Change the pressure to the transducer to the
desired pressure value and keep it constant.
6]
Enter the pressure values in the fields shown
above the graphic. The value in the corre-
sponding voltage or current field will follow
automatically.
7]
Move the cursor to the entry field for the
next pressure value. For quick navigation
between the fields use the arrow buttons
next to it.
The calibration data of each position is
stored automatically when moving the cursor
to the next field.
8]
Proceed in the same way to calibrate the
remaining positions.
9]
Type in a significant name for the transducer
into the “Transducer ID” field.
10]
Press the “Finish Calibration” button.
11]
Press the “BACK” button to leave this screen.
Defining angle transducers
1]
Press the “Angular” button on the “DEFINE
NEW TRANSDUCER” screen.
2]
Defining angle transducers is following the
very same procedure as defining motion
transducers, see section “Defining motion
transducer” above. The only difference is
that the quantity motion changes to angle.
Defining current transducers
1]
Press the “Current” button on the “DEFINE
NEW TRANSDUCER” screen.
2]
Press the “Supply” button repeatedly to se-
lect the correct power supply for the trans-
ducer.
3]
Enter the transducers ratio (current and volt-
age) and offset values.
4]
Type in a significant name for the transducer
into the “Transducer ID” field.
5]
Press the “BACK” button to leave this screen.
Defining voltage transducers
1]
Press the “Voltage” button on the “DEFINE
NEW TRANSDUCER” screen.
2]
Enter the transducers ratio values (Actual
voltage and Voltage).
3]
Type in a significant name for the transducer
into the “Transducer ID” field.
4]
Press the “BACK” button to leave this screen.