This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference with the equipment is operated in its
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the product manual, could cause harmful
interference to radio communications. If this equipment does cause harmful interference,
the user will be required to correct the interference.
Due to the phenomena being observed and the material properties being measured, this
equipment radiates radio frequency energy while in the active test mode. Care should be
taken to ensure this radio frequency energy causes no harm to individuals or other nearby
equipment.
Never exceed maximum operating capabilities of the Baker AWA-IV tester, power packs,
or the Baker ZTX accessory. If using the equipment in any manner not specified by
Megger, the protection provided by the equipment may be impaired.
Be sure to comply with all safety procedures prescribed by your organization, industry,
and governing standards. Failure to heedsafety precautions can result in injury or death
from severe electrical shock.
Additional information reference
The Baker AWA-IV Quick Reference Guide is intended to introduce users to the analyzer and its
basic operating procedures.
For complete safety information anddetailed information on the device, end-user license agreement,
and CE conformity refer to the Baker AWA-IV User Manual.
WARNING
CAUTION
NOTICES
www.megger.com
ii
