Preparing For Testing
SETTING UP A STEP-VOLTAGE TEST
1. From the DC TESTS screen, click on the drop-down list for
HiPot/Step
Voltage
then click on
Step
Voltage
as shown in the image below. This will open the Config Wizard.
Figure 14. Setting up Step-Voltage test parameters.
2. Set each value to a desired level and click
Next
.
Figure 15. Step-Voltage Configuration Wizard; setting voltage parameters.
3. Add or delete steps within this screen as needed, then click
Finish
to save the setup.
4. When you have completed your setup, close the screen.
www.megger.com
13
