Installation -
Installation - wall mount bracket
1.
Using the mounting template or the accessory itself, mark and
drill the necessary holes in the mounting surface.
2. Use the included screws and anchors to secure the wall mount to
the mounting surface.
3. Pass wires through the mounting bracket. Use the star wrench to
open the compartment between the wall mount and junction box.
4. Connect the camera’s base into the wall mount’s neck, and secure
using the screws on the side of the neck. Use the hexagonal
wrench to secure the screws in place.
5. Open the camera’s base by rotating the base clockwise to the
unlock position. Make sure the camera’s safety wire is connected
between the camera base and the camera module.
UNLOCK
LOCK
6. Connect all wires to the camera. Please refer to the camera’s QSG
for cable management.
7. Attach the camera’s body to the base by rotating the base
counter-clockwise to the lock position.
8. Place and secure the camera dome cover using the screws at the
base of the dome.
9. Remove the protection film when the installation is complete.
NOTE:
See the QSG for the mounting accessory for more information.
9
