EN
29
ATTACHMENTS
WARNING!
To avoid accidental starting, always check
that the rotation selector is in the middle
position before changing attachments or
doing something else to the tool.
Four different attachments are supplied with
the driver. Remove the rubber cap from the
chuck and press the attachment in place where
the rubber cap was. Release the attachment by
pressing in both lock buttons on the driver and
replacing the rubber cap.
FIG. 4
FIG. 5
Chuck attachment
The chuck attachment is used to tighten screws
to the set torque (10 positions).
Excentre attachment
The excentre attachment is used to drive in
screws near walls or other obstacles.
Right angle attachment
The right angle attachment is used for driving
in screws at right angles.
Cutter attachment
The cutter attachment is used for cutting soft
material, such as paper etc. with a thickness of
up to 6 mm.
BITS
WARNING!
To avoid accidental starting, always check
that the rotation selector is in the middle
position before changing attachments or
doing something else to the tool.
Fitting/removing
1. Put the bit in the chuck and press in place.
2. Pull on the bit a little to check that it is
properly inserted and does not come loose.
3. Remove the bit by pulling it hard so that it
comes loose from the chuck.
FIG. 3
SCREW DRIVING
1.
Fit suitable bits according to the instructions.
2. Hold the driver in a firm grip and put the
bit on the screw.
3. Start the driver by pressing the power
switch. Press the top part of the switch for
clockwise rotation and the bottom part for
anticlockwise rotation.
4. Release the switch to stop the driver.
NOTE:
• Do not force the driver and never
attempt to enlarge a hole by pushing
sideways. Allow the driver to do the job.
• Use bits that suit the shape and size of
the screws. Otherwise the bits and screw
heads can be damaged.
Summary of Contents for 004951
Page 4: ...1...
Page 5: ...2 4 6 3 5 7...
