EN
30
• Wipe clean the driver when necessary
with a soft, damp cloth. Do not use
solvents.
• Store the tool in a dry place at a
temperature of 0 to 50°C.
REPLACING THE CUTTING DISC
WARNING!
• To avoid accidental starting, always check
that the rotation selector is in the middle
position before changing attachments or
doing something else to the tool.
• Be careful when the disc is rotating - risk
of cut injuries.
IMPORTANT:
An arrow on the guard shows the
recommended direction of rotation for the
disc.
FIG. 6
1. Fit the cutter attachment on the tool. This
locks the motor spindle so that the screw
can be undone.
FIG. 7
2. Undo the screw (1).
3. Remove the disc (2) by pulling it down.
4. Press a new disc (2) in place from
underneath. Check that the round edge of
the disc is turned away from the tool.
5. Turn the disc (2) so that it fits in the
holder (3).
6. Tighten the screw (1).
7. The attachment is now ready to use.
MAINTENANCE
NOTE:
The manufacturer cannot accept liability for
personal injury or material damage if the
driver is repaired by unathorised personnel
or used incorrectly.
• When not in use, store the driver in a dry,
frost-free place out of the reach of
children.
Summary of Contents for 004951
Page 4: ...1...
Page 5: ...2 4 6 3 5 7...
