EN
50
push it in the battery compartment to lock it
in place.
FIG. 8
FIG. 9
WARNING!
Check that the power switch is switched off
before putting in the battery.
USE
SWITCHING ON AND OFF
Switching on
Move the power switch button forward and
press its front edge down to lock. The power
switch is now locked and the product runs
continuously.
Switching off
Press the back of the power switch button and
move the button back.
FIG. 10
ADJUSTING THE SPEED
The spindle speed can be adjusted with a knob.
The best speed to use depends on the material.
Practise by trial and error.
FIG. 11
BATTERY INDICATOR
The battery indicator shows the residual charge
in the battery when the product is switched on.
FIG. 12
Status
Significance
Red + green Full
Red + yellow
> 50%
Red
Low charge level
GRIP SURFACE
Hold the product firmly as shown in the figure.
FIG. 13
CUTTING
WARNING!
Always use the guard when cutting metal.
Do not press the tool too hard when cutting.
Do not put pressure on the cutting disc, or tilt
or wobble the tool..
Never attempt to stop the disc by pressing it
sideways.
The tool must always be moved against the
direction of rotation of the disc, so that the disc
works upwards. Otherwise there is a risk that
the disc will be forced out of the cut.
Start with the smallest dimension when cutting
profiles and rods.
FIG. 14
GRINDING
WARNING!
Never use cutting discs for grinding – risk of
personal injury.
IMPORTANT:
Never start the product with the disc touching
Summary of Contents for 019801
Page 4: ...1 1 2 3 4 5 6 7 8 9 12 13 11 10 ...
Page 5: ...2 4 6 3 5 ...
Page 6: ...8 10 12 9 11 7 ...
Page 7: ...14 16 15 13 ...
