EN
49
Disc diameter
Ø76 mm
Disc thickness
1.0 mm
Centre hole diameter
10 mm
Speed
20800 rpm
Peripheral speed
80 m/s²
DUST AND CHIP EXTRACTION
Dust from materials such as lead paint and
some types of wood, minerals and metals, can
be a health hazard and cause allergic reactions
or damage to the respiratory organs of users
and/or onlookers.
Dust from oak and birch, for example, is
considered to be carcinogenic, especially
in combination with some wood treatment
agents (e.g. chromates and wood
preservatives). Materials that contain asbestos
should only be handled by qualified personnel.
-
The work area should be well ventilated.
-
It is recommended to use a breathing
mask with a P2 filter. Always follow the
applicable regulations.
Use a dust extractor or clean the work area
frequently to prevent the accumulation of dust
– fire hazard or dust explosion.
BEFORE USE
Charging the battery
NOTE:
Only charge the battery with the supplied
charger.
If the battery is very hot, remove it from
the charger and allow it to cool to ambient
temperature before charging it.
The battery is uncharged on delivery. The
battery must therefore be charged before
using it for the first time.
Charge the battery to at least half capacity,
preferably full capacity, before putting into
storage. Charge the battery at intervals of 3
to 6 months if the product is not in use.
FIG. 7
Battery charging
1. Connect the charger to a power point.
2. Put the battery in the charger. The status
light goes red during the charging.
3. The battery is fully charged in about 1
hour. When the battery is fully charged
the status light goes from red to green.
4. Unplug the charger from the power point
and remove the battery from the charger
when it is fully charged.
WARNING!
If the battery is hot as a result for example of
intensive use, exposure to direct sunlight or
high ambient temperature, allow it to cool
before charging. A hot battery charges less
efficiently and will not reach its full capacity.
Charge indicator
Status
Significance
Constant red
light
Charging
Constant green
light
Fully charged
Removing and inserting the
battery
To remove the battery, press the battery lock
release button and pull out the battery from
the battery compartment. To insert the battery,
Summary of Contents for 019801
Page 4: ...1 1 2 3 4 5 6 7 8 9 12 13 11 10 ...
Page 5: ...2 4 6 3 5 ...
Page 6: ...8 10 12 9 11 7 ...
Page 7: ...14 16 15 13 ...
