Medtronic Guardian RT MMT-7900, User Manual

Page: 43 / 128

Getting Started 37
6.
If you choose the BEEP or BOTH alert, a number 2 (default) will appear blinking above the words
BEEP VOL. You can choose between three different beep volumes: 1 = Low, 2 = Medium, and 3 =
High. Use the Up or Down arrow button to choose 1, 2, or 3. (While scrolling, corresponding beep
tones will sound.)
7.
Press the ACT button to save your choice. The Set Time and Date screen will appear. Press SEL 6
times to go to EXIT. Press ACT to go back to the HOME screen.
Entering the Transmitter ID
Each Transmitter is given a unique 7-digit identification number in the factory, from 0000001 to 9999999,
which is the serial number shown on the Transmitter device label. This number (including leading zeros)
must be entered into the Monitor before glucose data sent from the Transmitter can be received and
stored in the Monitor. This will limit the Monitor to only receive data from the Transmitter with that ID
number. If a different Transmitter is used, the new Transmitter ID must be entered.
From the HOME screen:
1.
Press the SEL button 7 times until the SETUP screen appears.
2.
Press the ACT button once to go to the SETUP sub-screens.
3.
Press the SEL button 6 times until the ID sub-screen appears.
4.
Press the ACT button, and a 0000000 number will appear with the first digit blinking. Use the Up or
Down arrow button to choose the first digit in your Transmitter ID number.
BEEP VOL
2
TRANS ID