MEDION-Navigator 4.4
Installation and quick-start guide
- 17 -
2.2.4 Installation in the vehicle
Caution:
The mounted holder must not impede the driver’s
attention on the traffic. If this is not possible, mount the holder
somewhere else so that safe driving is granted. In case this is not
possible, use the provided adhesion plate to mount the holder
somewhere else so that safe driving is granted.
Note:
You need not execute steps 1 and 2 if you want to mount
the holder on your windscreen.
Mounting the
holder...
1. Remove the lamination sheet from the adhesion plate.
2. Stick the adhesion plate at a convenient place on the
dashboard. Make sure that the surface of the dashboard is
clean and dry and press the plate forcefully on its place.
Note:
Do not charge the plate for the first 24 hours in order
to grant its hold.
3. Attach the cradle of the device to the swan-neck mount.
Note:
Take note of the inscription on the swan-neck mount.
The arrow with the inscription
close
must show in snap-on
direction. The connection must snap on audibly.
4. Place the suction cup on the adhesion plate (or directly on the
windscreen) and press the lever on the suction cup down. The
suction cup adheres to the plate (or to the windscreen)..
5. Insert the device into its holder. First place the bottom of the
device correctly, and then push it backwards until it snaps
into the clip.
6. Insert the chinch jack of the power supply cable into the
respective socket at the bottom of the device.
