Medion F2 Revision 22, Operating Instructions Manual

Page: 49 / 70

27 of 48
NOTICE!
Only 3.5” hard drives can be installed in this mobile
rack. It is not possible to install a 2.5” SSD drive.
Proceed as follows:

Pull the mobile rack out of the slot.

Place the mobile rack onto a firm surface with the open side facing upwards. If
necessary, use a soft surface to minimise any knocks or collisions. The handle
must be facing in your direction.

Turn the hard drive so that you can see its lower surface and the contacts are
located in the top left.
Now insert the hard drive at an angle into one side of the mobile rack and
ensure that the metal pins on the hard drive decouplers fit into the screw holes
on the side of the hard drive.

Now carefully fold open the other side of the mobile rack so that the hard drive
can slide under the side strips.

Ensure that the metal pins on the hard drive decouplers also slide into the screw
holes on the other side of the hard drive. The hard drive is now locked in place
and it is not possible for it to slip out of position when inserting the mobile rack.

Turn over the mobile rack so that the top surface of the hard drive is facing
upwards and carefully slide the mobile rack into the slot until it clicks into place.
The hard drive will be recognised and can now be used.
NOTICE!
If the hard drive has been correctly installed, there will
be a gap of approx. 3 mm in front of the handle on the
mobile rack. If this is not the case, check once again
whether the hard drive is correctly locked in place via
the metal pins on the decouplers. If necessary, correct
the position of the hard drive and the decouplers.
9.2.2. Installing a 3.5” hard drive in a 2.5”/3.5” mobile rack
The mobile rack is made of metal and enables the hard drive to be installed without
the need for tools.
The 2.5”/3.5” mobile rack has a premounted hard drive decoupler, which consists of
a rubber bushing with two thin metal holding pins.
Proceed as follows:

Unlock the mobile rack by pressing the release lever.

Pull the mobile rack out of the slot.