Medion Erazer X7831, Instruction Manual

Page: 15 / 67

14 of 66
• Avoid dirt and contact with electrically conductive materials or
chemical substances and cleaning agents.
• Use only the supplied mains adaptor to charge the battery. Make
sure (via the Notebook display or acoustic signal) that the battery
is fully discharged before charging it again.
• Always charge the battery until the battery charging light goes
out. Please also observe the information in “Charging the battery”
to assess the charge status of your battery.
• Do not remove the battery while the Notebook is switched on or
data may be lost.
• Take care when storing the battery and when using the Notebook
that the contacts on the battery and the Notebook are not soiled
or damaged. This could cause malfunctions.
• Ensure the Notebook is switched off before replacing the battery.
2.11. Protecting the Display
• The display is the most sensitive component part of the notebook
as it consists of thin glass. It can break if subjected to too much
stress. Do not scratch the cover of the notebook, because it will not
be possible to remove any scratches.
• Avoid contact between the display and hard objects (e.g. buttons,
wristwatch).
• Do not place any objects on the display.
• Do not allow any objects to drop onto the display.
• Do not pour any fluids into the notebook, as this could damage it.
• Do not scratch the display with your fingernails or hard objects.
• Do not clean the display with chemical cleaning products.
• Clean the display with a soft, dry and lint-free cloth.
PLEASE NOTE!
The surfaces of the device are covered in protective film to prevent
scratching during production and transport.
Remove the film once the device has been set up properly and before
you use it.