Medion Erazer X7831, Instruction Manual

Page: 14 / 67

13 of 66
• Do not exchange the supplied cable for another one. Use only
the supplied cable as this cable has been extensively tested in our
laboratory.
• In addition, when connecting your peripherals only use the
connecting cables supplied with those devices.
• Ensure that all connection cables are connected to their
corresponding peripheral device to avoid any interference
radiation. Disconnect any cables that are not required.
• The only devices which may be connected to the Notebook are
those that meet the requirements set out in the EN60950 standard
“Information Technology Equipment – Safety” or devices that
meet the EN60065 standard “Audio, video and similar electronic
apparatus – Safety requirements”.
2.9. Information about the Touchpad
• The touchpad is operated with the thumb or another finger and
reacts to the energy given out by the skin. Do not use pens or
other objects as these can damage your touchpad.
• Dust or grease on the touchpad can affect its sensitivity. Remove
the dust or grease from the surface of the touch pad with a strip of
adhesive tape.
2.10. Battery
CAUTION!
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer‘s
instructions. Never attempt to disassemble or reassemble.
Do not heat up above 60°C (140°F). Do not dispose of in
fire or directly short circuit.
To extend your battery’s performance and lifespan and ensure safe
operation, you should also observe the guidelines below: