should not be adversely affected by infrared rays. Please, consult
your surgeon and implants manufacturer before the use of heat
directly on implants areas.*
4.
Heating the low back or low abdomen areas of a woman’s body
during the menstrual period may temporarily increase their
menstrual discharge.
Some women endure this process to gain the
pain relief commonly associated with their cycle,
whereas others
choose to avoid using the product during that time of the month.*
5.
It is reasonable not to use any heating pad on your groin area,
face, head, and other areas sensitive to heat
. If contraception
is not your aim,
do not apply heat to your genitals
.*
6. Children may use mats or other items with caution and under
the supervision of adults, preferably on low heat or negative
ions mode only.
Consult with the child’s pediatrician before using
the FIR pads and use common sense. Do not leave children or
toddlers on the mat or with the belt, wraps, or other hot stone
pad without supervision. They can walk, play or jump on the pad
with crystals and damage internal sensors. Children can disconnect
cables and put them into their mouths and get shocked. Take extra
care if your child has access to the room where the belt or hands
wrap or any other electrical device is located.*
7.
If you use medicines applied by skin patches, you should
consult your doctor
. The absorption rate of a transdermal
medication can change. If you use an adhesive, it may also unglue
from your skin due to sweating.*
8.
Cats and dogs love amethyst and gemstone mats. They feel some
energies better than humans. We suggest having
an additional
waterproof cover for the mat to protect it from any liquid and
make sure your pet will not chew or scratch the cable, controller,
or pad. We recommend non-powered, non-electric amethyst or
gemstone mats for pets.
Consult with a veterinarian before using the
mat for heating, Magnetism, or red light. Be careful with pets sleeping
on the device. It should always be turned off without supervision.*
9.
You should always drink A LOT before the session, during the
session, and after the session
— if you feel a dry mouth, there
is not enough water in the body. And it should not be just water;
you may need to replenish some electrolytes and minerals as Ca,
K, Mg, Na. Twitching may signify these salts’ severe deficit or
imbalance, so if you sweat a lot, herbal teas, fruit juices, and
mineral water rich in K and Mg or mineral supplements may be
necessary. Proper hydration also promotes all effects improving
detoxification caused by sweating.*
TIPS: TROUBLESHOOTING
10. Overusing the product at maximum temperature may result in
excessive stimulation.
Use moderately at high temperatures.
Even if your product can heat in a continuous mode, it is strongly
recommended not to use the high heat settings for more than 3 hours
for your safety! Some temporary symptoms of organism detoxification
(“healing crisis”) may occur, especially if you start too fast.*
11.
Detoxification high heat program should not be done without a
doctor’s approval and supervision.
Some drugs, chemicals, and
toxins which we take into our bodies with air or food end up getting
stored in our fat tissue. They can affect you as you mobilize them
and sweat them out. Before toxins are excreted and exit through
the sweat pores, they are absorbed from your decomposed by FIR
heat fat tissues into the bloodstream. While traveling on their way
to be eliminated, substances can exert the same effects that they
did when you had originally taken them. If a lot of residues were
accumulated in your fat tissue and their release is too fast, the
buildup of these poisons can make you feel worse. That is what
is called detoxification or a “healing crisis”. If you are chemically
allergic or extra sensitive, the dangers of infrared function
regarding the release of toxins may be severe. If you feel any signs
of a “healing crisis”, stop using the product and consult your doctor
as the same symptoms may also be the signs of serious illness.
12.
William Rea, MD, one of the most knowledgeable doctors in the
world regarding environmental toxicity and sauna detoxification,
warns:
“Uncontrolled, too-rapid mobilization can have
devastating effects on chemically sensitive patients”.
Of course,
it does not mean that chemically sensitive people cannot get rid
of toxins. Just that it should be done very slowly and carefully, and
with a doctor’s supervised detox program. Slowly and gradually
increasing heat level, session length, and frequency is the best
path forward, and It is essential to immediately decrease the
intensity, duration, and frequency of sessions and contact your
health professional if you feel symptoms of a “healing crisis”.*
13.
A very careful approach is appropriate to FIR heat function.
Our
skin sensors can easily detect the high temperature caused by
standard conduction heat, but our ability to feel the effects of
radiant infrared heat is limited.
The FIR warmth is much more
penetrating, so the hot stone pads should be used at a much
lower moderate temperature than a standard heating pad, and
it demands extra care, especially for extended or all-night use.
Use common sense, self-educate, listen to your body and we hope
you experience as many positive results as we have, now that you
have your ThermoGem™ Mat, Belt, Pad, or Wraps.
1.
Ensure the electrical wall socket that you’ve plugged the
apparatus into is working correctly
. Plug another device into it
to ensure it has power. If it is not working, consider checking the
electrical panel as a breaker may have popped (or broken) and
needs to be reset. Or try another electrical wall socket that you
have verified is powering other devices. If you are using a surge
protector, ensure it is working correctly. Plug another electrical
device into and verify that it is working.
2.
Ensure the controller’s plug is pushed into the belt’s receptacle
socket so that it is snug tight with no space at all between the
plug and the mat’s (belt’s or pad’s) or hands wrap’s socket.
A
loose connection can cause loss of signal exchange between the
mat with crystals and the controller, and when too many errors
accumulate, the controller’s calibration may fail. The controller will
show error messages, or the apparatus will not heat up properly.
3.
Make sure that the power button on the controller has been
turned ON
. The controller may show
OFF
on display. It means
that either preset heating time is over or the connection between
controller and belt or hands wrap is lost. Try adding time,
powering the controller ON/OFF, or reconnecting it.
4.
Please activate the timer button and choose one of the timer settings
to start heating.
Some models of the controllers do not activate
the heating function unless a timer is set
.
5.
The frequent reason for the new controller fault and errors is an
incorrect order of controller connection.
Please, first connect
the pad, mat, belt, or wraps to the controller, and only after
this plug the controller into an electrical outlet and turn the
controller ON.
When you disconnect, first turn it OFF, disconnect
the plug from the socket, and only after this unplug the controller
from the apparatus. If you connect the controller to the power
source first, the safety program may lock it and go into safe mode.
It may start to beep or will show
OF
or
OP
error on the screen.
The same may happen if there is a loss of signal interchange
between the belt or hands wrap and the controller. To reset it, just
reconnect it in the correct order.
6. If the controller shows errors, the easiest way to solve the
www.MediCrystal.com
9
®
EN
