5595.A
6
NOTES
The TEMP 3
may be left on continually without harm to the unit. It is suggested that each
facility should contact the fluid manufacturer to obtain the manufacturer’s specifications for time
and temperature for the fluids being warmed.
The TEMP 3
is not intended for Blood or Blood Products.
In the event that fluid should spill inside the cabinet – unplug the unit to prevent an
electrical shock hazard and refer to step #4 of the Cleaning instructions.
The Documentor
®
Resetting Instructions
TO CHANGE THE DATE:
1.
Plug The Documentor
®
into an electrical outlet.
2.
Press and hold blue RESET button located on the bottom of the The Documentor
®
.
3.
While holding down the RESET button, press and hold the
•
right button on the front panel.
4.
While holding the
•
right button, release the RESET button.
5.
When “
Prog”
appears in the display, release the
•
right button,
Prog
finishes.
6.
Tap the
•
right button again. The display will show “0000” and the 1
st
digit will flash.
7.
Tap the left button until the number “8” appears, then Tap the
•
right button twice so the third
“0” is flashing.
8.
Tap the left button until the number “8” appears in the third position then Tap the
•
right button.
9.
Tap the
left button until the number “8” appears in the fourth position. When the display reads
“8088”, Tap the
•
right button.
10.
When the display flashes all four digits, Tap the
•
right button.
11.
The display flashes “
P1(date)”
.
12.
Tap the
•
right button and the small digits on the left, representing the year, will flash.
13.
Tap the left button until the desired number appears and then Tap the
•
right button. The digits
representing the month should flash.
14.
Tap the left button until the desired number appears and then Tap the
•
right button. The digits
representing the day should flash.
15.
Tap the left button until the desired number appears and then Tap the
•
right button.
16.
When the desired date is set, Tap the
•
right button until the display flashes “
P1 (date)”
.
17.
Tap the blue RESET button to return to the standard display.
TO CHANGE THE TIME:
18.
Follow steps 1-11.
19.
Tap the left button. When the display flashes “
P2 cloc”
, Tap the
•
right button.
20.
The hour format will flash (12 or 24). If necessary, tap the
left button until 24 flashes. Tap the
•
right button.
21.
The hour digits will flash. Tap the left button until the desired setting is achieved. (the hour
must be set in military time 3:05 pm = 15:05) Tap the
•
right button
22.
The minutes digits will flash. Tap the
left button until the desired setting is achieved. Tap the
•
right button twice.
23.
The display will flash “P2 Cloc”, Press and release the blue RESET button.