3. Installation of the ColumbaTD System
Then, install the bracelet with the ColumbaTD around the wrist of the wearer, and identify the bracelet openings in which the lock
must be screwed. The openings must be chosen in order to prevent the wearer from taking the bracelet off without unbolting the lock.
Be sure the wearer is comfortable enough and that blood flow is not impeded. DO NOT OVER TIGHTEN THE BRACELET TO
AVOID INJURIES.
The ColumbaTD bracelet must be worn on the wrist, the incline face of the ColumbaTD towards the body.
3.2. Charger Installation and charge of the battery block
3.2.1. Installation and positioning of the charger
Insert the wire of the transformer in the plug located behind the charger. Plug the transformer in a wall plug. A blue light will turn on
when the charger will be ready to function.
The charger has a 2,4 GHz transmitter that creates a perimeter (RF zone) in which the ColumbaTD is p
lace
in RF mode (this will be
fully explain in section 4.1).
Positioning the charger in the wearer’s home is therefore very important. The charger should preferably be placed near the center of
the house, so that the RF zone covers the greatest area of the residence. A wrong positioning of the charger might cause an
increase of the energetic consumption of the ColumbaTD, because of the small area covered by the RF zone. (in which the
consumption is reduced)
The charger should be placed flat on a stable surface. It is preferable to place it out of reach of the ColumbaTD wearer.
Summary of Contents for ColumbaTD
Page 1: ......
