MECHAPRO Slider SFX, Manual

Page: 3 / 24

Manual Slider SFX Page 3
The structure of this manual…
This manual provides you with all information necessary to use your
Slider SFX
. It is divi-
ded into different chapters, the contents of which are summarised below:
Chapter 1:
Short introduction and technical details
Chapter 2: Procedure for initial operation, pin out
Chapter 3: Safety instructions
Table of content
1 What is Slider SFX used for? ........................................................................... 4
1.1 Versions of Slider SFX ..................................................................................... 5
1.2 Optional 4th axis ............................................................................................ 6
2 Start of operation ........................................................................................... 7
2.1 Base settings on delivery ................................................................................ 8
2.2 Mounting and ventilation ............................................................................... 8
2.3 Mounting dimensions .................................................................................... 9
2.4 X4 – Power supply ......................................................................................... 9
2.5 X10 – Control signals ..................................................................................... 10
2.6 JP1-JP8 – Jumper settings, signal assignment .................................................. 11
2.7 JP6 – Pin14 drives relay 2 or PWM logic .......................................................... 12
2.8 JP10 – Toggle signal, safety function .............................................................. 12
2.9 JP11 – Start up time ...................................................................................... 13
2.10 JP12 – Invert relay signals ............................................................................... 13
2.11 X3(1/2) – Emergency stop .............................................................................. 13
2.12 X7 – Inputs for limit and reference switches ................................................... 14
2.13 X2 – Switching outputs .................................................................................. 14
2.14 X3(3/4) – Analogue output signal for spindle control ...................................... 15
2.15 X6, X8, X11 – Motor connectors .................................................................... 16
2.16 X5 – Additional capacitor ............................................................................... 17
2.17 S1/S2/S3/S5 – Setup of motor current and step width .................................... 17
2.18 LED’s / status signals ....................................................................................... 18
2.15 X13 – Connector for external LED’s ................................................................ 19
2.20 X1 – Fan connector ........................................................................................ 19
2.21 X9/X14 – Extension for 4th axis ...................................................................... 20
3 Safety instructions .......................................................................................... 22