mecalac AX 1000, Operating Instructions Manual

Page: 75 / 144

P0700/P0710/P0850/P0860/P1000/P1010 8-9
Maintenance 8
Figure 8-17
Figure 8-16
8.2.9 Oil level check , planetary gear
(1) Move the loader until the marking line ”OIL LEVEL” is
horizontal and the plug is located above the top left of the
marking line (8-16/arrow).
(2) Unscrew the plug.
NOTE
- The oil level must reach the plug bore.
- Collect any oil that escapes.
(3) Fit a new gasket and screw the plug back in.
8.2.10 Oil change, planetary gear
(1) Move the loader so that the plug (8-17/arrow) is
positioned at 6 o’clock.
(2) Place an oil drain vessel with a drain channel under-
neath the gear.
(3) Unscrew the drain plug and let the oil drain out.
CAUTION
Waste oil must be disposed of in such a way that
it will not cause pollution!
(4) Move the loader until the marking line ”OIL LEVEL” is
horizontal and the plug is located above the top left of the
marking line (8-16/arrow).
(5) Fill in oil via the plug bore until the oil level reaches the
opening.
(6) Use a new gasket when screwing the plug back in.
8.2.11 Oil change, hydraulic system
(1) Open the motor hood.
(2) Place an oil drain vessel (at least 70 l) to the right below
the counter weight.
(3) Unscrew the oil drain plug (8-18/arrow).
(4) Drain the oil into the oil vessel.
CAUTION
Waste oil must be disposed of in such a way that
it will not cause pollution!
(5) Screw in the oil drain plug again.
(6) Change the hydraulic oil filter cartridge (section
8.2.12).
Figure 8-18