MDS NETio Series, Installation & Operation Manual

Page: 62 / 96

54 MDS NETio Installation & Operation Guide MDS 05-4457A01, Rev. A
Invisible place holder
Figure 3-8. Analog Output Menu
Figure 3-9 shows a simple representation of a NETio Unit that uses
WeXP.
Invisible place holder
Figure 3-9. I/O Mapping Concept with WeXP
To map an Analog Input connected to Module ID 2 to the Analog Output
on the Base Module, follow these steps:
1. Go to the Analog Output Menu for Analog Output # 1 on the Base
Module (see Figure 3-8 ), and select C to enter the source address.
2. NETio prompts you for three entries as follows:
a. The Unit ID of the Source Signal. (In this example, the Unit ID
is 7771.)
• Unit ID = 7771
•
Base Module ID = 0
•
Expansion Module ID= 1
• Module ID = 2
NETio Unit
7771
with WeXP
•
Module ID = 3
I/O Mapping