eMINI fogger
User Guide, Rev: A/a, April 2020
6 / 28
BASIC
DESCRIPTION
The
eMINI
fogger was designed with safety and reliability in mind. It is capable of generating pure white,
non-toxic fog for as long as you have fluid (100% duty cycles).
The
eMINI
is a variable output fogger capable of generating large volume of dense fog in a short period of
time. This fogger must be used in a well-ventilated area.
At the heart of the
MDG fogger
is an electronic assembly that keeps the heat exchanger(s) at a very stable
temperature, with three different types of fail-safe systems. Those three types of electronic fail-safe systems
are designed to protect against over and under-heating conditions and against component failure. When
an overheating condition is detected, or if the internal temperature of the fogger reaches 60°C (140°F), a
safety circuit is triggered. This circuit removes the power to the heating elements, preventing hazardous
conditions.
When an under-heating condition occurs, the fogger will stop producing fog until the temperature of the
heating module is back within parameters.
The temperature of the heat exchanger is maintained within a narrow margin. If an error occurs (see FAIL
State), the fogger will automatically shut down. When one of the safety systems is activated, the Fail state
will be displayed on the LCD, in the Status Menu. Check the
FAIL State
and
Troubleshooting
paragraphs
for diagnostics, then shut down the main power switch, wait 30 seconds, and then switch the fogger back
on. If the failure persists, send your fogger back to an authorized service center for verification.
When « Fog On » mode is activated (DMX or Control Menu), the MDG
eMINI
fogger will produce fog for
as long as the ready level is reached (temperature) and all other control parameters are within specifications.
Never remove the power to a fogger while it is producing fog
–
See the
Shut down procedure.
WARNING
•
When not in use,
ALWAYS
switch off the power switch located on the back panel and
disconnect the AC line
.
•
Never install above people.
•
This
eMINI
fogger must be installed in an upright position on a stable and leveled
surface.
•
Use in a well-ventilated area.
•
Do not operate at less than 2 meters (6.5 ft.) from people.
Summary of Contents for eMINI
Page 2: ...eMINI fogger User Guide Rev A a April 2020 2 28 Intentionally left blank...
Page 25: ...eMINI fogger User Guide Rev A a April 2020 25 28 DIMENSIONS...
Page 27: ...eMINI fogger User Guide Rev A a April 2020 27 28 DECLARATION OF CONFORMITY...
Page 28: ...eMINI fogger User Guide Rev A a April 2020 28 28 NOTES...
