PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
30
Operation
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
D
E
ON
OFF
6.1.
SETTINGS TO CARRY OUT BEFORE FIRST
LIGHTING
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position
(I).
The lighted button will come on and also LED
C
of the emergency panel
will come on steady red.
6.2.
Start-up/shutdown from emergency panel
If the remote control is defective or the batteries are dead, you can
temporarily run the stove from the rear emergency panel.
In this configuration, the stove can operate only in manual mode and
with possibility to select from
3
levels of power.
LIGHTING THE STOVE WITHOUT THE REMOTE
CONTROL
To light the stove, place selector
“D”
to
ON.
At start-up the
red LED goes off and the green LED will start flashing until the
start-up phase is complete. At full operating power the green
LED will come on steady.
SELECTING POWER WITHOUT REMOTE CONTROL
You can choose from three levels of heating power:
MIN-MED-MAX
(selector
“E”
)
MINIMA
power is the 1st power;
MEDIUM
power is the 2nd power;
MAXIMUM
power is the 3rd power;
SHUTTING DOWN THE STOVE WITHOUT THE REMOTE
CONTROL
To shut down the stove, place selector
“D”
to
OFF.
Once the remote control is working again, remember
to put selector "D" back in the "REMOTE" position.
Otherwise the stove will disregard inputs from the
remote control.
