5
4. INSTALLATION OF LCD REMOTE CONTROLLER
4.1Accessories
The following accessories are included. If any part is missing, contact your dealer immediately.
1
Remote controller
2
Wooden screw 4.1 x 16 (2 pieces)
3
Instruction manual
4.2 Step-by-step guide
i)
First, open up the casing of the LCD remote controller
into its top and bottom
case using a
screwdriver. To do this, insert the screwdriver into the lower slot and slide it in the outward direction.
ii)
Fix the bottom case onto the wall with the 2 wooden screws provided. Then, insert the 4 connecting
wires (from the main board) through the slot on the lower right.
iii)
Connect one end in each of the 4 wires to the terminal block behind the top case as shown below.
The wire that goes into the "GND" terminal at the top case must be connected at the other end to the
“GND" terminal at the main board. The same goes for the "+5V", "B" and "A" connection.
iv)
Fasten back the top and bottom case into place. Hook the two upper claws into their respective slots
and snap the lower part shut.
5. AUTO RANDOM RESTART
When power resumed, the unit will automatically restart and operate at the previous setting as before power
failure occurred. (Remove jumper at JH/JP1 will cancel the auto random restart function. Please refer to
wiring diagram for the location of the JH/JP1).
Error
code
Possible fault
Error
code
Possible fault
E01
Require manual reset (possible causes)
E19
Indoor coil sensor 4 short
E02
Compressor 1 high temperature (overload)
E20
Indoor coil sensor 1 open
E03
Compressor 2 high temperature(overload)
E21
Indoor coil sensor 2 open
E04
Compressor 3 high temperature(overload)
E22
Indoor coil sensor 3 open
E05
Compressor 4 high temperature(overload)
E23
Indoor coil sensor 4 open
E06
Compressor 1 high pressure trip / contact open
E24
Outdoor coil sensor 1 short
E07
Compressor 2 high pressure trip / contact open
E25
Outdoor coil sensor 2 short
E08
Compressor 3 high pressure trip / contact open
E26
Outdoor coil sensor 3 short
E09
Compressor 4 high pressure trip / contact open
E27
Outdoor coil sensor 4 short
E10
Compressor 1 trip / low R-22 / outdoor abnormal
E28
Outdoor coil sensor 1 open
E11
Compressor 2 trip / low R-22 / outdoor abnormal
E29
Outdoor coil sensor 2 open
E12
Compressor 3 trip / low R-22 / outdoor abnormal
E30
Outdoor coil sensor 3 open
E13
Compressor 4 trip / low R-22 / outdoor abnormal
E31
Outdoor coil sensor 4 open
E14
Room sensor short
E32
Compressor 1 de-ice
E15
Room sensor open
E33
Compressor 2 de-ice
E16
Indoor coil sensor 1 short
E34
Compressor 3 de-ice
E17
Indoor coil sensor 2 short
E35
Compressor 4 de-ice
E18
Indoor coil sensor 3 short
Summary of Contents for MDB075B
