McLaughlin VERSA-MOLE McL-10H, Components And Repair Manual

Page: 44 / 47

12. Remove all paint and corrosion from around the
front side mounting holes on the strike alert mount
plate. NOTE: There must be a good contact
between the strike alert and the frame. Paint, rust
and corrosion, around the mounting bolts can pre-
vent the strike alert from working properly.
13. Tighten the two (2) nuts on the back of the strike
alert.
STEP 6: CONTROL VALVE INSTALLATION
14. Place the valve under the console plate and insert
and tighten the three (3) screws for the valve.
15. Connect the hoses to the proper fi ttings. Refer to
the Hydraulic Schematic section of the manual. Be
careful not to cross or twist hoses. Route hoses
away from moving components and away from
possible damage.
STEP 7: SHUTTLE VALVE INSTALLATION
16. Install the proper fi ttings into the valve.
17. Noting the previous orientation, screw the valve to
the underside of the console.
18. Connect the hoses to the valve fi ttings. Refer to
the Hydraulic Schematic and Console Assembly for
proper fi ttings and valve orientation.
STEP 8: PRESSURE GAUGE INSTALLATION
19. Apply a small bead of pipe sealant (Loctite #592, or
equivalent) around the end of the fi tting.
20. Tighten the gauge into the console fi tting. Position
the gauge appropriately.
SECTION 4: BREAKOUT WRENCH
ASSEMBLY & DISASSEMBLY
DISASSEMBLY
STEP 1: BREAKOUT WRENCH REMOVAL
1. Disconnect the supply hoses from the control
valve.
2. Remove the breakout hold down angles.
3. Lift the breakout out of the carriage and place on a
solid surface.
4. Mark, disconnect and cap the supply hoses from
the breakout manifold.
STEP 2: CLAMP CYLINDER DISASSEMBLY
5. Remove the two (2) screws which hold the jaw to
the mtg. block.
6. Disconnect and cap both the hoses and fi ttings of
the clamp cylinder.
7. Remove the R-clip pin and remove the cylinder pin.
8. Pull the cylinder up and out of the breakout.
9. Remove the dowel pin which holds the jaw mtg.
block to the cylinder rod.
STEP 3: MANIFOLD REMOVAL
10. Mark, disconnect and cap all remaining hoses and
fi ttings. Leave the fi ve (5) top hoses connected.
11. Remove the three (3) screws which hold the mani-
fold to the breakout front plate.
9.8.0
5
8
9
10
12