McLaughlin VERSA-MOLE McL-10H, Components And Repair Manual

Page: 37 / 47

REPAIR INSTRUCTIONS
McL-10H VERSA-MOLE
SECTION 1: CARRIAGE ASSEMBLY
& DISASSEMBLY
STEP 1: CHAIN GUARD REMOVA
L
DISASSEMBLY
1. Remove the swivel at the back end of the spindle.
2. Remove the seven (7) screws from the back of the
chain cover.
3. Pull the cover away from the carriage.
4. Remove the seal carrier from the inside of the
chain cover. Inspect for damage. Replace if nec-
essary.
STEP 2: CHAIN & SPROCKET REMOVAL
5. Loosen the set screws in the small sprocket.
6. Remove the screws which hold the bushing to
the large sprocket. Loosen the set screw directly
above the keyway in the shaft.
7. Reinsert the screws into the tapped holes in the
bushing. Tighten all the screws alternately to
“walk” the bushing out of the sprocket.
8. Once the bushing is loose, walk both sprockets and
the chain away from the back plate.
9. Find and remove the master link in the drive roller.
Check the chain, sprockets and bushing for wear
and replace if necessary.
WARNING:
Moving parts. Keep all guards in place. Shut
down engine before service or maintenance.
Being caught in machinery may cause serious
injury.
WARNING:
High Pressure. Leaking hydraulic fl uid under
pressure can penetrate and cause serious in-
jury. Check for leaks with cardboard. Relieve pressure
WARNING:
Crushing weight can cause serious injury.
Place machine on solid surface to prevent
rollover or falling.
WARNING:
Do not modify this machine. Use only au-
thorized McLaughlin repair parts. Failure to
comply can result in serious injury. Service
this equipment according with maintenance instructions
in this manual.
9.1.0
5
6
9