McLaughlin VERSA-MOLE McL-10H, Components And Repair Manual

Page: 43 / 47

studs. NOTE: The smooth, coated side should be
facing in toward the center of the machine. Also,
the conveyor should be slightly above the top of the
frame angle.
50. Install the two (2) machine screws at each end of
the conveyor belt.
51. Install the conveyor side sheets. The long leg of
the sheet should be on the top side of the studs.
52. Install and tighten the nuts to hold the conveyor in
place.
STEP 14: SIDE SHEET INSTALLATION
53. Install the side sheets by setting it into the bottom
slots and pushing down and in.
54. Reinstall the R-clip pins in the side sheet studs.
Do not operate machine without guards properly in
place.
SECTION 3: CONSOLE DISASSEM-
BLY & ASSEMBLY
HYDRAULIC ADJUSTMENTS
The control valve contains the following:
One (1) non-adjustable relief valve preset
@ 2500 psi / 170 BAR.
The main system relief is non-adjustable.
DISASSEMBLY
STEP 1: CONTROL VALVE REMOVAL
1. Mark the hoses with their corresponding fi tting
location on the valve.
2. Disconnect and cap both the hose and the fi ttings
to prevent oil loss and contamination.
3. Remove the three (3) nuts which hold the valve in
place. Remove the valve.
STEP 2: PRESSURE GAUGE REMOVAL
4. Unscrew the pressure gauge from the console
fi tting.
STEP 3: SHUTTLE VALVE REMOVAL
5. Remove the two (2) screws which mount the shut-
tle valve to the console. NOTE: Mark the orienta-
tion of the #1, #2 and #3 ports on the shuttle valve.
These ports will be important in replumbing the
valve.
STEP 4: STRIKE ALERT REMOVA
L
6. Remove the two (2) screws which hold the female
receptacle to the console.
7. Remove the two (2) nuts which hold the strike alert
to the console.
8. Pull the strike alert down to expose the wire con-
nections. NOTE: Mark the positive (+) and nega-
tive (-) wires before disconnecting them.
9. Remove the strike alert and the female receptacle.
ASSEMBLY
STEP 5: STRIKE ALERT INSTALLATION
10. Install the female receptacle on the console.
11. Wire the strike alert to the female receptacle.
9.7.0
51
4
5
8
12