EXTender 6000 Quick Installation Guide
24
Asynchronous-Serial (RVP_Direct)
This section of the manual provides the necessary information to configure the EXTender for connection
to an asynchronous-serial device. The units are programmed at the factory with “default” settings
providing basic parameters to accommodate many network environments.
ISDN
Branch Office
Punch Block
EXTender 6000
Punch Block
PBX
Corporate Office
PBXgateway
ISDN TA
ISDN TA
Figure 12: RVP_Direct Async Connections
Prerequisites for Configuration
•
The Gateway (at the corporate site) and the EXTender (at the branch office) must be installed
properly and the network link between both devices must be operational.
•
The network administrator must assign an IP address for both units in order to configure and test
them over a LAN or WAN.
Table 7:
Basic Configuration
You must….
To….
Default
Setting
Refer
to…
Set the Primary Dial
Numbers (DNs)
Identify the first and second ISDN
B-channels at the Gateway unit.
- page
25
Set the mode (interface
type) of the WAN port.
Match the interface type of the net-
work device.
V.35
page 26
Set the Async parameters
for the selected WAN port
Match the settings for the device
being used.
- page
26
