McIntosh MCD7008, Owner'S Manual

Page: 8 / 24

ANALOG OUTPUT/VARIABLE
Provides a variable output volume level that can be controlled by the front panel Volume
control as well as by the Up[ ]and Down[ ] pushbuttons on the HR7008 hand held remote
controller.
CONTROL
This connector is used with the 7 pin DIN cable to connect to a Mclntosh remote controlled
preamplifier, receiver, or remote control system. This will allow their hand held remote con-
trollers to operate six functions of the MCD 7008 player.
These functions are PLAY, NEXT (Track), BACK (Track), NEXT (Discs 1 through 6), BACK (Single
Disc) and STOP NEXT (Track) and BACK (Track) can be performed after playback has started.
NEXT (Discs 1 through 6) and BACK (Single Disc) can be performed when the player is in STOP mode.
Press the NEXT button and you will select disc number 1. Press NEXT again as desired
to select discs 2 through 6. Press BACK to select the disc in the SINGLE position.
DATA IN
This connector jack allows serial remote control from an accessory component. An exam-
ple would be to connect to this jack from the DATA OUT jack on a Mclntosh preamplifier
or remote control system, so the HR7008 Remote Controller will transmit to the preamplifier.
This method of operation provides all the functions of the HR7008 Remote Controller, transmit-
ted to the preamplifier sensor. It is then not necessary to point the HR7008 toward the CD
player for all normal player functions.
DIGITAL OUTPUT/COAXIAL
An electrical coaxial output connector is provided for external digital signal processing.
OFF-ON SELECTOR SWITCH:
OFF is for normal operation of the player when using either pair of analog output jacks.
ON provides the digital output at the COAXIAL output jack. This digital signal may then
be connected to an external Digital-to-Analog Converter or digital signal processor with a coax-
ial cable.
AC POWER
The MCD 7008 is designed to operate on 50 or 60Hz, 120 volt AC power. It draws 22 watts
of power when operating.
REAR PANEL
MEMORY
A: CANCEL: Used to cancel selected disc tracks stored in memory.
B: REVIEW: Allows you to review all the selected tracks on all discs you have stored in memory.
C: ENTER: Used to store each selected track in memory.
D: POWER: Turns the main power ON or OFF.
E: TIME DATA: Used for reading into the player's memory the number of tracks and playing
times of all the discs stored into the player.
F: MODE: Allows you to select the following displays.
TIME mode: Elapsed time of the current track.
FRONT PANEL