McIntosh MCD7008, Owner'S Manual

Page: 7 / 24

HOW TO INSTALL
THE BATTERIES
IN THE HR7008
REMOTE
CONTROLLER
Slide open the cover of the battery compartment. Insert the two supplied size AA batteries
into the compartment. Be sure to observe the correct polarity of the batteries as indicated
in the battery compartment.
When the batteries are nearing exhaustion, the effective range of the remote controller
decreases, and MAY even fail to operate. In this case, replace both batteries with fresh ones.
NOTE:
- Do not use a mixture of old and new batteries.
- Make sure both batteries are of the same type.
- To prevent damage caused by possible battery leakage, remove the batteries from the
remote controller if it is not to be used for an extended period of time.
- Never dismantle batteries or dispose of them in fire, as they may explode. Dispose of bat-
teries only in an approved method for proper safety.
HOW TO
INSTALL
THE PLAYER
The MCD7008 can be placed upright on a table or shelf, standing on its four plastic feet.
The player also can be custom installed in a cabinet of your choice. The panel cutout and
player dimensions are shown in the diagrams found on page 19 of this manual.
The player is held in place by two angle brackets mounted to the back panel of the player
chassis. The brackets attach to the player with two 6/32 x 3/8 inch machine screws, and to
the mounting shelf with two 6 x 1/2 inch wood screws.
Always provide for adequate ventilation. Never place the player directly above a heat
generating component such as a high powered amplifier. Cool operation insures a longer
operating life for any electronic instrument. Allow at least 1 1/2 inches (3.8 cm) above the player
so that airflow is not obstructed. The recommended minimum space for a custom installation
is 18 1/2 inches (47.2 cm) wide, 6 inches (15.2 cm) high by 17 1/2 inches (44.5 cm) deep in-
cluding connectors. Allow 1 inch (2.54 cm) in front of the mounting panel for knob clearance.
HOW TO
CONNECT FOR
NORMAL AUDIO
PLAYBACK
The last page of this manual folds out to show photographs of the front and rear panel
of the MCD7008. Fold it out to assist you in locating the volume control and identifying all
the pushbuttons and their functions.
NORMAL PLAYBACK
Connect a shielded cable from the LEFT (L), of either the FIXED or VARIABLE ANALOG
OUTPUT jacks to the LEFT channel CD INPUT of the amplifier, preamplifier or receiver being
used. Connect the RIGHT (R) channel OUTPUT to a similar RIGHT channel input.
MAKE SURE THE DIGITAL OUTPUT SWITCH IS IN THE OFF POSITION
AC POWER
Connect the player power cord to an AC outlet, 50 or 60Hz, 120 volts. This can be a wall
outlet or an AC outlet provided on accessory equipment.
REAR PANEL
ANALOG OUTPUT/FIXED
Provides a fixed output volume level.
6