McDonald's 9210859, Manual

Page: 11 / 28

HEBT-3V BUN TOASTER
11 P/N 1011377 Rev. G 07/17
McDonald’s
Figure 9. Conveyor Locks
Figure 8. Conveyor Rollers
MAINTENANCE (continued)
Quarterly
Remove Belt Wraps and Clean Rollers
1. Turn the toaster’s power switch to the off position.
The toaster enters a cool-down mode and will
automatically shut down when complete.
2. Unplug the power cord once the cool-down period
is complete.
NOTE: Wait for the cool-down period to complete
before unplugging the power cord.
3. Remove the bun feeder using heat-resistant
gloves.
4. Remove the front and rear conveyor covers by lift-
ing up and away from the unit. Set the compres-
sion knob to 7.
NOTE: Reposition the toaster as needed to perform
these steps.
5. Unlock the lock on the left side panel with a flat-
head screwdriver and open the panel. Set the bun
compression knob to 7.
6. Push down on the front and rear belt rollers and
move them away from the center of the toaster.
Use both hands. This removes tension and locks
the rollers in place.
7. Lift the upper belt frame lock. Then rotate down
so it rests on the camshaft of the rear belt roller.
8. Pull down the lower belt frame lock. This provides
access to the front and rear belt rollers and belts.
9. Carefully remove both of the belts from the toast-
er.
10. Wipe all four rollers and backing plates with a
clean, damp sanitized towel. Make sure to remove
all debris from the rollers and the backing plates
so they are as clean as possible.
11. Use a dry cloth towel or nylon-bristled brush to
remove all debris from both side compartments,
inside of the toaster, and underneath the rollers.
Upper Belt
Frame Lock
Lower Belt
Frame Lock
Tense
Loose
Loose
Tense
Figure 10. Belt Wraps
Rear
Belt Wrap
Front Belt Wrap