HEBT-3V BUN TOASTER
8
P/N 1011377 Rev. G 07/17
McDonald’s
Daily Cleaning
Clean the Toaster and Belt Wraps
1. Turn the toaster’s power switch to the off position.
The toaster enters a cool-down mode and will
automatically shut down when complete.
2. Remove the bun feeder and bun stop with heat-
resistant gloves.
3. Remove the front and rear conveyor covers with
heat resistant gloves.
4. Inspect the front belt for any tears, discoloration,
or dam-age to the Belt Wrap snaps. Replace
any damaged Belt Wrap as needed. With with
proper maintenance the belt can six months or
longer. Refer to PR 68 Q1 and PR 68 Q2 for belt
replacement instructions.
5. If the front belt is in good condition, spray a
clean, damp sanitized towel with Sink Detergent
solution. Wipe the front belt clean. Rinse the front
belt with a separate clean, damp sanitized towel.
Allow to air dry.
NOTE: The belt rollers will continue turning while
in cool-down mode. This allows you to clean the
entire belt. Only clean the belt where it is in front of
the Backing Plate to avoid causing dam-age to the
belt. Repeat this step several times if there is heavy
carbon buildup on the conveyor belt.
6. Inspect the rear belt for any tears, discoloration,
or damage to the Belt Wrap snaps. Replace
any damaged Belt Wrap as needed. With with
proper maintenance the belt can six months or
longer. Refer to PR 68 Q1 and PR 68 Q2 for belt
replacement instructions.
7. If the rear belt is in good condition, spray a clean,
damp sanitized towel with Sink Detergent solu-
tion. Wipe the rear belt clean. Rinse the rear belt
with a separate clean, damp sanitized towel.
Allow to air dry.
NOTE: The belt rollers will continue turning while in
cool-down mode. This allows you to the entire belt.
NOTE: Only clean the belt where it is in front of the
Backing Plate to avoid causing damage to the belt.
MAINTENANCE
Figure 3.
8. Wash, rinse, and sanitize the bun feeder and bun
stop in the three-compartment sink. Allow to air
dry
9. Wash, rinse, and sanitize the front and rear con-
veyor covers in the three-compartment sink.
10. Reinstall the clean front and rear conveyor covers.
11. Reinstall the clean bun feeder and clean bun stop.
12. Clean the outside surfaces of the toaster with
clean, damp sanitized towel sprayed with Heavy
Duty Degreaser Solution. Rinse with a clean,
sanitizer soaked towel and allow to air dry.
13. Turn the unit on.
14. Place all used towels into the soiled towel bucket.
Summary of Contents for 9210859
