ALARM MESSAGES
Copyright © 2018 McCrometer, Inc. All printed material should not be changed or altered without permission of McCrometer.
Any published technical data and instructions are subject to change without notice. Contact your McCrometer representative
for current technical data and instructions.
www.mccrometer.com
3255 WEST STETSON AVENUE • HEMET, CALIFORNIA 92545 USA
Printed In The U.S.A.
TEL: 951-652-6811 • 800-220-2279 • FAX: 951-652-3078
Lit. # 30122-46 Rev. 1.2 / 5-31-18
40
CODE
MESSAGE
CAUSE
ACTION
ALARM
VIA
SMS *
193
CONFIG.ENTERED
The system detects an
access to the configuration
parameters
Check the events log and do the
appropriate action depending on
your data protection policy
YES
194
CLOCK S.FAIL
The clock synchronization
with the remote server failed
Check the server configuration,
the GPRS network conditions and
antenna signal
YES
195
POWER FAILURE
The system experienced a
power failure (loss of power)
Check the status of the batteries
and all their connections. THIS
MESSAGE MAY APPEAR WHEN
THE SYSTEM IS SWITCHED OFF
WITHOUT PRIOR PUTTING IT IN
STAND-BY MODE
YES
206
F.SENSOR ERROR
The system detected one or
more errors in the flow sensor
Check the error code in the
events log
YES
207
TEMP.>FS
The external temperature is
higher than the full scale set
Check the maximum full scale set
and the process conditions
YES
208
PULS.2>F.MAX
The pulse frequency at
output 2 is too high
Reduce the pulse duration if the
connected counter allow this or
increase the pulse unit value
YES
209
PRESS.2>FS
The Pressure at input 2 is
higher than the full scale set
Check the maximum full scale set
and the process conditions
YES
210
EL.SIG.ERROR
The system detected an error
condition on the measuring
electrodes
Check the flow sensor cables, the
electrodes surface, the grounding
and the process condition
YES
211
EXCIT.ERROR
The system detected an error
in the coils excitation circuit
Check the flow sensor cables, the
coils insulation and resistance
YES
212
SD MEMORY FULL
The SD card memory is full
(no more space for new data)
Change the SD card memory or
erase all the unwanted data
YES
215
POWER SUPPLY OFF
The power coming from the
universal power supply went
off
Check the power supply source
and the relative cables
YES
216
SD MEMORY ERROR
The SD card installed is
missing, not valid, not
formatted or incompatible
with the system
Replace the SD memory, format it
or check if it is properly inserted
YES
*Not available at this time.
