MCCI Catena 4611, User Manual

Page: 9 / 21

Catena 4612/4611 User Manual
Engineering Report 234001173 Rev A
- 9 -
Figure 5 1x04 Screw Terminals
4.3 Antenna
Whip Antenna, u.FL and SMA Antennas can be used. The antenna specifications are shown in Table 2
Figure 6 Whip Antenna
Table 2 Antenna Specification
Parameters Reference US Version EU Version IN Version AU Version AS Version
Wire Color Yellow Green Blue Yellow Yellow
Reference Number 123001007 123001069 123001070 123001007 123001007
Wire length L1 88.6 84.2 88.9 82 82
Tolerance - +/- 0.3 mm +/- 0.3 mm +/- 0.3 mm +/- 0.3 mm +/- 0.3 mm
Board thickness W1 1.5748 1.5748 1.5748 1.5748 1.5748
Tin length L2 3 mm 3 mm 3 mm 3 mm 3 mm
Tin tolerance - +/- 0.03 mm +/- 0.03 mm +/- 0.03 mm +/- 0.03 mm +/- 0.03 mm
Slop from soldering L3 1.5 mm 1.5 mm 1.5 mm 1.5 mm 1.5 mm
Minimum length - 80.9 80.9 85.6 80.9 80.9
Maximum length - 82.9 82.9 86.6 82.9 82.9
Typical length L4 81.9 81.9 87.6 81.9 81.9
Minimum f - 903.83 MHz 903.83 MHz 855.33 MHz 915 MHz 920 MHz
Maximum f - 928.80 MHz 928.80 MHz 875.87 MHz 928 MHz 925 MHz
Typical f - 915 MHz 915 MHz 866 MHz 921 MHz 923 MHz
4.4 Programming Requirements
4.4.1 ST-LINK/V2 in-circuit debugger/programmer
The ST-LINK/V2 (123001120) is an in-circuit debugger and programmer for the STM8 and STM32
microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD)
interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application
board.